ZTE MF 637
по инструкции тоже не получается
Jan 1 02:00:00 syslogd started: BusyBox v1.16.1
Jan 1 02:00:00 kernel: klogd started: BusyBox v1.16.1 (2010-06-29 22:32:02 EEST)
Jan 1 02:00:00 kernel: CPU revision is: 00029006
Jan 1 02:00:00 kernel: Primary instruction cache 16kB, physically tagged, 2-way, linesize 16 bytes.
Jan 1 02:00:00 kernel: Primary data cache 16kB, 2-way, linesize 16 bytes.
Jan 1 02:00:00 kernel: Linux version 2.4.37.9 (root@localhost) (gcc version 3.4.6) #8 2010-07-01 22:47:12 EEST
Jan 1 02:00:00 kernel: Setting the PFC to its default value
Jan 1 02:00:00 kernel: Determined physical RAM map:
Jan 1 02:00:00 kernel: memory: 02000000 @ 00000000 (usable)
Jan 1 02:00:00 kernel: On node 0 totalpages: 8192
Jan 1 02:00:00 kernel: zone(0): 8192 pages.
Jan 1 02:00:00 kernel: zone(1): 0 pages.
Jan 1 02:00:01 kernel: All bugs added by David S. Miller <davem@redhat.com>
Jan 1 02:00:01 kernel: VFS: Mounted root (squashfs filesystem) readonly.
Jan 1 02:00:01 kernel: Mounted devfs on /dev
Jan 1 02:00:01 kernel: Freeing unused kernel memory: 92k freed
Jan 1 02:00:01 kernel: Warning: unable to open an initial console.
Jan 1 02:00:01 kernel: Algorithmics/MIPS FPU Emulator v1.5
Jan 1 02:00:01 kernel: eth0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.150.10.29
Jan 1 02:00:01 dnsmasq[68]: started, version 2.52 cachesize 512
Jan 1 02:00:01 dnsmasq[68]: compile time options: IPv6 GNU-getopt no-RTC no-DBus no-I18N DHCP no-scripts no-TFTP
Jan 1 02:00:01 dnsmasq-dhcp[68]: DHCP, IP range 192.168.1.2 -- 192.168.1.254, lease time 1d
Jan 1 02:00:01 dnsmasq[68]: read /etc/hosts - 2 addresses
Jan 1 02:00:01 kernel: usb.c: registered new driver usbdevfs
Jan 1 02:00:01 kernel: usb.c: registered new driver hub
Jan 1 02:00:01 kernel: usb-uhci.c: $Revision: 1.275 $ time 22:38:53 Jun 29 2010
Jan 1 02:00:01 kernel: usb-uhci.c: High bandwidth mode enabled
Jan 1 02:00:01 kernel: PCI: Enabling device 01:03.0 (0000 -> 0001)
Jan 1 02:00:01 kernel: UHCI: Enabling VIA 6212 workarounds
Jan 1 02:00:01 kernel: usb-uhci.c: USB UHCI at I/O 0x100, IRQ 12
Jan 1 02:00:01 kernel: usb-uhci.c: Detected 2 ports
Jan 1 02:00:01 kernel: usb.c: new USB bus registered, assigned bus number 1
Jan 1 02:00:01 kernel: hub.c: USB hub found
Jan 1 02:00:01 kernel: hub.c: 2 ports detected
Jan 1 02:00:01 kernel: PCI: Enabling device 01:03.1 (0000 -> 0001)
Jan 1 02:00:01 kernel: UHCI: Enabling VIA 6212 workarounds
Jan 1 02:00:01 kernel: usb-uhci.c: USB UHCI at I/O 0x120, IRQ 12
Jan 1 02:00:01 kernel: usb-uhci.c: Detected 2 ports
Jan 1 02:00:02 kernel: usb.c: new USB bus registered, assigned bus number 2
Jan 1 02:00:02 kernel: hub.c: USB hub found
Jan 1 02:00:02 kernel: hub.c: 2 ports detected
Jan 1 02:00:02 kernel: usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
Jan 1 02:00:02 kernel: PCI: Enabling device 01:03.2 (0000 -> 0002)
Jan 1 02:00:02 kernel: ehci_hcd 01:03.2: PCI device 1106:3104
Jan 1 02:00:02 kernel: ehci_hcd 01:03.2: irq 12, pci mem c01a2000
Jan 1 02:00:02 kernel: usb.c: new USB bus registered, assigned bus number 3
Jan 1 02:00:02 kernel: EHCI: Enabling VIA 6212 workarounds
Jan 1 02:00:02 kernel: ehci_hcd 01:03.2: USB 2.0 enabled, EHCI 1.00, driver 10 Dec 2004/2.4
Jan 1 02:00:02 kernel: hub.c: USB hub found
Jan 1 02:00:02 kernel: hub.c: 4 ports detected
Jan 1 02:00:02 kernel: usb.c: registered new driver usblp
Jan 1 02:00:02 kernel: printer.c: v0.13: USB Printer Device Class driver
Jan 1 02:00:02 kernel: Linux video capture interface: v1.00
Jan 1 02:00:02 kernel: SCSI subsystem driver Revision: 1.00
Jan 1 02:00:03 kernel: Initializing USB Mass Storage driver...
Jan 1 02:00:03 kernel: usb.c: registered new driver usb-storage
Jan 1 02:00:03 kernel: USB Mass Storage support registered.
Jan 1 02:00:03 kernel: hub.c: new USB device 01:03.2-2, assigned address 2
Jan 1 02:00:03 dnsmasq[68]: read /etc/hosts - 2 addresses
Jan 1 02:00:03 dhcp client: deconfig: lease is lost
Jan 1 02:00:04 kernel: scsi0 : SCSI emulation for USB Mass Storage devices
Jan 1 02:00:04 kernel: Vendor: ZTE Model: MMC Storage Rev: 2.31
Jan 1 02:00:04 kernel: Type: Direct-Access ANSI SCSI revision: 02
Jan 1 02:00:04 kernel: Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Jan 1 02:00:04 kernel: sda: Waiting for disc 0 to settle.
Jan 1 02:00:06 kernel: sda: Unit Not Ready, sense:
Jan 1 02:00:06 kernel: Info fld=0x0, Current 00:00: sns = f0 2
Jan 1 02:00:06 kernel: ASC=3a ASCQ= 0
Jan 1 02:00:06 kernel: Raw sense data:0xf0 0x00 0x02 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00
Jan 1 02:00:07 kernel: sda : READ CAPACITY failed.
Jan 1 02:00:07 kernel: sda : status = 1, message = 00, host = 0, driver = 08
Jan 1 02:00:07 kernel: Info fld=0x0, Current sd00:00: sns = f0 2
Jan 1 02:00:07 kernel: ASC=3a ASCQ= 0
Jan 1 02:00:07 kernel: Raw sense data:0xf0 0x00 0x02 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00
Jan 1 02:00:07 kernel: sda : block size assumed to be 512 bytes, disk size 1GB.
Jan 1 02:00:07 kernel: Partition check:
Jan 1 02:00:07 kernel: /dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
Jan 1 02:00:07 kernel: I/O error: dev 08:00, sector 0
Jan 1 02:00:07 kernel: unable to read partition table
Jan 1 02:00:18 wan: connected manually
Jan 1 02:00:20 wan: connected manually
Jan 1 02:00:22 wan: connected manually
Если можно дайте настройку под ZTE MF 637
а инструкцию я читаю так уже начитался что голова уже кругом идет - одно я знаю что данный мопед очень проблемный во всех отношениях и по разлочке и по настройке не ужели он у меня один есть же народ у которого он козел работает так дайте настройки и дело с
концом
|